Synetic Inc. SyneRAID-800B Fibre-to-UDMA/100 RAID Subsystems, Intel i80303 64bit RISC processor controller, 64MB Cache, support Dual FC-AL loop, 2Gbit/sec per loops, 8xHot Swap canister , Rackmount 3U (дисковый массив)

SyneRAID - 800B (8 x IDE Drives)

SyneRAID-800B RAID subsystems are designed to offer high performance, reliability and cost-effective alternative to high cost Fibre RAID subsystems.

SyneRAID-800B RAID subsystems support Fibre host interface connections and utilize low-costs IDE drives. A simplified storage setup and management makes these units an ideal RAID, data storage and backup solutions for small to mid-sized companies and departments.

          High Performance:

	SyneRAID-800B uses high performance Intel i80303 64bit RISC processor and its intelligent cache system supports up to 256Mbytes DRAM for data caching, to simultaneously distribute multiple requests from the host computer to connected IDE hard drives to perform high speed parallel data transfer.
	To increase the data transfer, SyneRAID-800B implements the " Single drive per independent channel " architecture to provide high sufficient data throughput per channel and eliminates disk multitasking overhead.

	Advanced algorithm to provide RAID level 0,1,3, 5 or 0+1, so that you can benefit from, either the performance and availability of RAID 0+1, or the capacity and economy of RAID 5.
	Providing duplex and redundancy power/cooling fan systems which can tolerate a mains failure without interrupting services.
	Hot swapping of disk drives, cooling fans and Power supplies allows for easy swapping of faulty parts without loss of service from RAID and systems down time.
	IDE disks in a single disk per channel configuration lower the risk of failure.
	Hot spare function for disk drives allows the replacement of bad drive when any error occurs on any of the drives. The on-line hot-spare disk drive will automatically take over for the failed disk drive leaving you with hand free support.
	Automatic drive failure detection with drive online drive rebuild enables you to replace the hard drive without having any operations or commands. It transfers data into the replaced hard drives automatically.
	Operating Systems independence feature can offer access to data storage with different OS platforms such as; Windows Me//98, Windows 2000, Widows NT, NOVELL, UNIX, Linux, Solaris or Macintosh are compatible and transparence.