Qlogic SANblade QLE2360 Fibre Channel (FC) Card/Host Bus adapter (HBA), Single Port (1 channel) 2GB, PCI Express X4, Multi-mode Optic, OEM (оптиковолоконный контроллер)

Оптиковолоконный контроллер Qlogic SANblade QLE2360 Fibre Channel (FC) Card/Host Bus adapter (HBA)

The QLE236x is a high-performance, 2-Gbps to PCI-Express HBA. The QLE2360 is a single port HBA, the QLE2362 is a dual port HBA. Unlike other HBAs, the QLE236x delivers unprecedented levels of performance and availability. All HBAs in the SANblade QLE236x family are managed by the QLogic SANsurfer FCHBA Manager, which provides centralized management and remote control of distributed HBAs. Why PCI Express? PCI Express is a serial host bus that provides higher throughputs, lower pin counts, and ease of scalability. This technology is being adopted by major server OEMs. PCI Express x4,supported by the QLE236x, provides 2-GBps FC data rate, addressing increasing higher throughput requirements. Higher Performance. The QLE236x has an enhanced RISC processor on the FC controller chip, providing up to 160,000 I/Os per second by having completely independent, internal resources for each port. Simplified Management. The QLogic SANsurfer FC HBA Manager is a simple and easy to use device management tool for the installation, configuration, and management of QLogic HBAs. TheQLE236x is fully compatible with management applications that support the SNIA API and SMI-S standard, allowing IT managers to manage QLogic HBAs through third-party software applications.

Features and Benefits 2-Gbps fibre channel (FC) to PCI Express™x4 host bus adapter (HBA)   Up to 160,000 IOPS delivers high I/O transfer rates for storage applications SANsurfer® FC HBA Manager allows for centralized management and remote control   Native support for all major operating systems, including Microsoft® Windows 2003, Windows® 2000, Red Hat™ Linux™, and SuSE Linux   Single and dual channel versions maximize performance and take advantage of PCI Express slots   Auto-negotiation of FC speed (1-Gbps or 2-Gbps)   Concurrent support for SCSI and IP protocols   HBA and LUN level failover   Local and remote management   Load balancing for optimized performance   Enhanced beacon/LED indicators   Proactive failure detection and alerts Storage networking industry association (SNIA) HBA application programming interface (API), and storage management interface Specification (SMI-S) compliant.

Specifications

Host Bus Interface Specifications Bus-Interface 2.5 GHz PCI Express x4 Memory 1-MB SRAM per port, 1-MB flash, and 4-Kb NVRAM Compliance PCI Express Base Specification rev. 1.0a, PCI Express Card Electromechanical Specification rev. 1.0, PCI Local Bus Specificationrev. 2.3, PCI Bus Power Management Interface Specification revision.1.1 Fibre Channel Specifications Data rate 2/1 Gbps auto-negotiation (2.1240/1.0625 Gbps Performance 83,000 IOPS per port Throughput 380 MBps at full-duplex per port Topology FCAL, FCAL-2, point to point, switched fabric (FL_Port and F_Port) Class of service Class 3 FC service Protocol SCSI-FCP, FC-TAPE Buffer credits 3 credits available per port (2,112 Byte frame payload) Compliance Second Generation FC Generic Services Definition (FC-GS-2), Third Generation FC Generic Services Definition (FC-GS-3), Fibre Channel-Physical and Signaling Interface (FC-PH), SCSI-3 Fibre Channel Protocol (SCSI-FCP), Fibre Channel-Arbitrated Loop-2 (FC-AL-2), Fibre Channel-Private Loop Direct Attach Technical Report (FC-PLDA), Fibre Channel Framing and Signaling (FC-FS), SCSI-3 Architecture Model (SAM), and SCSI-3 Controller Command Set Physical Specifications Ports One (QLE2360); Two (QLE2362) Media Multimode optic Form factor Half size: 16.76 cm×11.12 cm (6.6"×4.376") Bracket size Standard size Connectors LC-style connectors that support non-OFC, multimode fibre optic cabling using a small form factor optical transceiver modules (one in the QLE2360, two in the QLE2362) Optics Short wave laser Environment and Equipment Specifications Airflow None required Temperature Operating: 0°C/32°F to 55°C/131°F. Storage: -20°C/-4°F to 70°C/158°F Humidity Relative (non-condensing): 10% to 90%, Storage: 5% to 95% Cable 50/125µm multimode fiber, 62.5/125 µm multimode fiber Power dissipation QLE2360: ~9.5W (1.7W @ 3.3V; 7.8W @ 12V)QLE2362: ~12.5W (2.3W @ 3.3V; 10.2W @ 12V) Distance 1 Gbps: 500 meters 50/125 µm fiber, 300 meters 62.5/125 µm fiber2 Gbps: 300 meters 50/125 µm fiber, 150 meters 62.5/125 µm fibe Software Applications SANsurfer® FC HBA Manager, SANsurfer® FC CLI, SANsurfer® Express Operating systems Windows® Server™ 2003; Windows 2000; Linux Red Hat AS 3.0; Linux SuSE SLES 8, 9; Novell NetWare 6.5 HW platforms IA32 (x86), IEM64T Flash utilities Utilities for firmware, driver, boot code, and NVRAM Boot support BIOS Compliance SNIA HBA API V2, SMI-S, FC-SP/DH-CHAP, and FDMI